Our services

Energy engineering consulting for industrial gases

We always start from what can be measured in your installation: flows, purities, pressures, kWh. With those data we design a solution whose impact you can verify afterwards, not just believe.


Pressure gauges in an industrial gas system
Measure before deciding: on-site audit and diagnosis
01

On-site gas generation

Independence, efficiency and control

Producing nitrogen or oxygen at your own plant from compressed air. You stop depending on deliveries, and the cost per Nm³ becomes mostly electricity.

Want to understand how PSA works before deciding anything?

PSA technical guide — N₂ / O₂ →
  • Analysis of the real consumption profile
  • Sizing of the PSA generator
  • Supervision of installation and commissioning
  • Feasibility study with detailed ROI
Typical payback
18–36 months
Depending on consumption and energy tariff
Savings versus cylinders
60–80%
In cost per Nm³ produced
Available purity
95% → 99.999%
N₂ and O₂ depending on application
02

Industrial energy optimisation

Reducing consumption without compromising the process

We look for where energy is lost in your gas and compressed-air systems: leaks, excess pressure, over-specified purities. You receive a report with the actions ranked by how much they save.

Compressed-air systems: leaks and pressure
Existing PSA generators: real efficiency
Distribution infrastructure
Consumption patterns and oversizing
03

Gas consumption audit

Know before you act

What is not measured is assumed, and assumptions are expensive. We measure real consumption at each point of use and compare it with what you pay, so you can decide with data.

Measurement of real consumption per point of use
Gas quality analysis: purity, moisture
Comparison of billed and real consumption
Technical report with diagnosis and recommendations
04

Turnkey projects

From engineering to operation

We support you from start to finish: initial analysis, specification, suppliers, installation, commissioning, validation and training of your team.

Detailed engineering and specifications
Supplier and equipment management
Acceptance testing and validation
Complete technical documentation
3D render of a nitrogen generation room with compressor, dryer and PSA generator
3D design of the generation room before installation
Typical case

Expanding an N₂ plant without stopping production

A second generator in parallel, its own air treatment and purity protection on each branch. This is how we approach an expansion: first the diagram, then the plant in 3D.

Drag to rotate the plant and tap any unit to see its data sheet. Open full screen →

Request a no-obligation technical consultation

We read your enquiry personally and reply within 48 working hours at most.

Request a technical consultation →
WhatsApp